Your Micro-SD card: 

• A Micro SD card (not included) needs to be inserted into the dash camera and formatted for the first time to enable recording.
• Class 10 or above with storage capacities from 32GB to 128GB maximum. The Micro SD card is not included with your purchase.
• Press and hold the Wi-Fi button on the dash camera for at least 8 seconds to format the memory card and restore the dash camera to factory settings.  

Installing dash camera:

You may use the electrostatic film to enable an easy removal of the dash camera from the windscreen. Before mounting, please ensure you thoroughly wipe the glass clean. Proceed to tear off the protective layer of the electrostatic film and adhere it to the windscreen whilst pushing out any bubbles that appear.

1. Peel off the protective cover of the 3M adhesive tape on the dash camera mount and position the dash camera in the middle of the electrostatic film (if used) or directly to the windscreen if not. Press down the mount and hold for about 30 seconds to ensure good adhesion. Then adjust the lens of the camera by rotating the barrel to face the road ahead. 
2. Plug the supplied Type-C Charger cable into the dash camera USB port and the other adaptor into the vehicle’s 12/24V output port. Run the dash camera cable along the top of the front windshield through the A-pillar and around the storage compartment. Use the supplied pry tool to help tuck in the power cord.
3. To remove the dash camera from the mount, slide the dash camera to the left of the mount as shown below.

Powering on your dash camera:

Plug in the 12/24V adaptor into the vehicle’s 12/24V output port. When the vehicle ignition is turned on, the dash camera will power up and start recording automatically. The dash camera will shut down once the vehicle ignition is turned off. 

• If you wish to use features such as parking monitor or time lapse parking monitor, you require the dash camera to be powered using the 3-wire hardwire kit. This can be found at: Smart 3-Wire Hardware Kit – NanoCamPlus